Then add a new multihop configuration file by modifying an existing one. The port 3004 is the multihop port for nl1.Ĭhoose a multihop port from our server page. To do this, you would connect to :3004 and use the public key of the nl1 server. The PublicKey is that of the exit server.įor example, let's say you want to connect to nl1 via se4 (so nl1 is the exit server). In the WireGuard configuration file the Endpoint port defines the exit server, and the preceding IP-address or hostname defines the entry server: "INSERVER-IP:OUTSERVER-PORT". One way to do this is to connect to a specific port on a WireGuard server which will then connect to the other WireGuard server via the tunnel. This means you can multihop from one server to another. Multihop can be used for many different reasons, for example, increasing your privacy or improving latency/performance due to suboptimal ISP peering.Įach WireGuard server is connected to all the other WireGuard servers through WireGuard tunnels. To verify that WireGuard is working, use our Connection check to check your IP. DisconnectĪs before, you may replace "se3" with the currently used region. Note: Make sure that the configuration file name is no more than 15 characters long (not including ".conf"). You may replace "se3" with any of the other regions found on our server page. You will otherwise likely run into connectivity issues. If you're running WireGuard on multiple devices, generate a separate key pair for each device.
Run our configuration scriptĬurl -LO & chmod +x. Sudo apt-get update & sudo apt-get install curl jq openresolv wireguardįor non-Debian based distributions, follow WireGuard's official installation instructions. The Mullvad VPN app for Linux uses the WireGuard protocol by default, so all you need to do is connect.
We also have an easier setup guide which makes use of our browser-based config generator. This advanced terminal-only guide will teach you how to use the WireGuard® protocol to connect to Mullvad using Linux.
0 kommentar(er)
